SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

PXC3.E75 in the FAULT state ?

10/27/2017 2:28 PM	Rate (0)
Vasia Pupkin Posts: 55 Rating: (1)	Good time, experts !!! We have a PXC3.E75 with the LED FLT continuously ON ... Is this a hardware error or just something like COMA state and it can be reanimated ? Is it possible to recover the device in some way ?
Vasia Pupkin Posts: 55 Rating: (1)
Suggestion To thank Quote Answer

10/30/2017 2:02 PM	Rate (0)
Albis Posts: 387 Rating: (130)	Dear Vasia, You have to distinguish between the PXC3.E75 and the PXC3.E75-100A. In case of the PXC3.E75, you can follow the steps below: Interrupt the power supply of the PXC3.E75 controller for 20 seconds Try to connect with the DNT tool If you can reach the controller, please load the firmware again, configure the controller and load the application. You have to replace the controller, in case you cannot reach the controller with the DNT tool anymore Best regards, Albis
Albis Posts: 387 Rating: (130)
Suggestion To thank Quote Answer

10/31/2017 1:34 PM	Rate (0)
Jen_Moderator Posts: 8171 Rating: (174)	New question published by Andrey Zozulyak is split to a separate thread with the subject Is there any possible way to download new firmware not using DNT Tool?. Best regards Jen_Moderator
Jen_Moderator Posts: 8171 Rating: (174)
Suggestion To thank Quote Answer

Share this page:

Share this page on...