Hello I am sending data from Sentronpac to flexible wincc I send data of voltages and currents I receive correctly.

But I am not receiving the data from Active Energy Import tariff 1 correctly.  The data type of sentron pac according to the manual is Double.

How can I configure in wincc so that it shows me the correct data.

Can somebody help me?​

------------------------------------------------------------------------------------------
Split from Communication with WinCC flexible 2008.

edw44

Hello I am sending data from Sentronpac to flexible wincc I send data of voltages and currents I receive correctly. 

 But I am not receiving the data from Active Energy Import tariff 1 correctly.  The data type of sentron pac according to the manual is Double.

 How can I configure in wincc so that it shows me the correct data.

Can somebody help me?​

Have you used the links above your post?

Hi edw,

maybe the following links are helpful for you, if not than please tell us exactly where you have problems.

Ayman Elotaify

Tweety

Hello,

Perhaps you can communicate about OPC, if your analyzer can communicte about OPC.
You find more information OPC in chapter 4.
SIMATIC HMI WinCC flexible 2008 Communication Part 1

You find in the following manual which plc can you communicate with WinCC flexible.

SIMATIC HMI WinCC flexible 2008 Communication Part 2

Tweety

 

Hello,

I think the following links will help you. It is based on how to get data from Siemens Power meters "SENTRON PAC" directly to WinCC or WinCC flexible.

Displaying data of SENTRON PAC3200 / PAC4200 in WinCC flexible via über Ethernet

Simple Introduction into Energy Management with WinCC

Hope it helps.