Hi, 

Struggling to get a SMS through to the Logo PLC.

I can write to an output on the CMR2020 with the following:

LOGO;OUTPUT=O1,1 or  LOGO;OUTPUT=O1,0 works fine

From the user manual:

LOGO;LOGO OUTPUT=O5,1 should work but doesn't  .

I get a reply "invalid command"

if i send LOGO;LOGO=O5,1

i get a reply "invalid Parameter"

I also cannot write to a flag either.  Presumably Syntax incorrect but cannot solve so any help appreciated.

Cheers

.

Have you set the password for the write commands?

Are you using the correct password?

New question published by Pawel Feliks is split to a separate thread with the subject How to create a signal, event, action and assignment definition in the logo cmr?.

Best regards
Jen_Moderator