Hello

Can i convert a Protool file to Wincc 2008 sp3 file?

Thanks 

Adi

------------------------------------------------------------------------------------------
Split from Wincc 2008 sp3.

mr.adi

Hello

Can i convert a Protool file to Wincc 2008 sp3 file?

 Hello,

You should migrate Protool to WinCC flexible SP2 then convert it to WinCC flexible SP3

Ok but where can I download WINCC sp2 and have any problem if i install both of them on my pc?

thanks 

ADI

mr.adi

Ok but where can I download WINCC sp2 and have any problem if i install both of them on my pc?

thanks 

ADI

It is not possible to install SP2 + SP3 on same OS but you may use a virtual machine.

Or upload your ProTool Project to forum, perhaps somebody can transform to WinCCflexSP2 for you.

Hi mr.adi

in the Past you had to use the following MLFB to get the SP2 DVD S79220-B2389-P.

But The Siemens Mall says that it is not available anymore. But you can try to contact your local Siemens Contact. In most Cases they can provide you with older Installation DVDs.

Bye Murof