Hi To All,

I am using CU310 2-Pn Controller With S7300 Controller. I have Some Doubt with Acceleration and Deceleration In Position Control [MDI].

Settings: -

• Lu/Load Revolution = 10000 LU
• Gear Ratio = 45.4
• Max. Acceleration= 75 1000LU/ S²
• Max. Deceleration = 751000 LU/ S²
• Velocity Set point = 600 1000LU/MIN
• Velocity OverRide=100%
• Acceleration OverRide=100%
• Deceleration OverRide=100%

I Know If My Velocity Setpoint Is 600 1000LU/MIN then  My Motor runs at 2724 RPM . Then What is the Acceleration and Deceleration time to at the Given Setpoint.

Kindly Help Me

Dear Tech Team,

Thanks for your Reply.  

New question published by MBS is split to a separate thread with the subject Is it possible to make acc & dec time zero?.

Best regards
Jen_Moderator