Hi,

I have a problem on my tia project,

i can not see on the hardware configuration online the i/os cards of the ET200SP.

The error message is , "hardware component not available due to a parameter assignment error, parameter assignement in progress"

BR

Hello,

Always provide the detailed statement of your problem so we can figure out solution .

Which software version are you using for configuration of ET200SP station? (Step 7 5.5 or Step 7 V13)

Have you enable the 1st module as new potential group for its base unit? So it will act as power module like ET200S

Connect the 24 volt supply only for white color bade unit.

Have you address server module at last slot of SP ?

With latest Step 7 5.5 n Step V13 SP1 Bydefault  it will add.

Have you checked the power budgeting of ET200 SP?

Cause may be Inbeteen module you need to enable the new potential group for base unit of module.

At last, i know you have configured the profinet name for ET200SP as online name and offline name in project. Both should be match.

Give us the exact screen shot of CPU and ET200 sp diagnostic buffer.

If you feel this post is useful then don't forget

Hi Dj_1 thanks for your answer,

Which software version are you using for configuration of ET200SP station? (Step 7 5.5 or Step 7 V13) :  i use a step 7 V13 SP1 update 9

Have you enable the 1st module as new potential group for its base unit? So it will act as power module like ET200S: I have several module that are potential group and i enable them as potential group in my Hardware Config

Connect the 24 volt supply only for white color bade unit.

Have you address server module at last slot of SP ? YES

With latest Step 7 5.5 n Step V13 SP1 Bydefault  it will add.

Have you checked the power budgeting of ET200 SP?

Cause may be Inbeteen module you need to enable the new potential group for base unit of module.

At last, i know you have configured the profinet name for ET200SP as online name and offline name in project. Both should be match: They are matched,

Give us the exact screen shot of CPU and ET200 sp diagnostic buffer.: attached the screen shot

If you feel this post is useful then don't forget

Hello,

Your wiring looks good,

Can you send the diagnostic buffer info of CPU. Have you assigned the same device name to ET200SP as available in your project?

Also go online with SP and take snap shot of  ET200SP hardware and post it here?

Hello,

As per your screen shot, its problem of module version. Online module version and off;line module version is not matching.

For example, 8DI module online version is 2.2 and you have configured may be 2.1

Check the all online and offline module version. Right click on each module and click  change the device. you will find the other available version. After changing, download hardware configuration and then let see.

If you feel this post is useful then don't forget to rate