Hello,

What's the message appearing on your AOP?

jaafer

Thank you for attention MR Elotaify...

i have used this product for 6 years and for some new requirement  i have to change AOP parameter so before i replaced the battery, the AOP was showing this message

(Battery Low    P

No Language - Load May Not Work !

P:ACK. Fn:Restart

)

It should be noted that this message has been showing for a long time but I did not care about it,

and when i decided to  replacing with new battery the AOP Showing this message

(AOP is Slave to PC   P

AOP Requires Rebuild

P to Exit When Done

)

and unfortunately no access to any parameter 

thank you agine

 Hello,

If No language installed on the AOP, you will need to replace it. 

The AOP comes with 5-languages installed. Sometimes we need to delete one or more to free a space on the AOP allowing upread a drive parameters or more drives up to 10. If -by mistake- you deleted all 5-language, you won't be able to re-install them again. 

Hello,

Please see the attached AOP manual,

And see the bellow statment extracted from it:

Memory Limitation
The AOP supports five European Languages; English, German,
French, Spanish and Italian.Due to internal memory limitations
the user should delete one of these languages in order to
upread the specified ten parameter sets that can be held on
the AOP.
¾To Delete a Language
Select “Language” from the top level menu, highlight the language
you want to delete then press “Fn” and “↑”.Please note that
once a Language has been deleted it cannot be restored.