Subhro

Hello Mr. PISCEAN 2010,

Armatures are controlled by two separate Simoreg CM (configured in Master and Slave). Armatures are not in series. Only fields of both the motors are in series and controlled by a separate DC Master.

Field referncing is done by the Master Armature controller as per the speed requirement.

Master Armature controller works in speed mode.
Slave Armature controller works in current mode. Speed controller is bypassed in it.
From master K141 is sent to slave. and it is connected to slave drives P601.

In both master and slave controller P169 = 1 and P170 = 0

Both the motors are solidly coupled back to back in Tandem.

Hope the configuration is clear now.

Sir I wan to in brief how control to field by master armature controller and 

Both motor in tendon so we are using single encoder for speed feedback ,so I want know speed feedback will connect in parallel in master slave drive?

------------------------------------------------------------------------------------------
Split from Simoreg Control for two Motors (Master & Slave) in Tandem having different Open Circuit Charecteristics.