SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Problem with fault F006

6/26/2012 4:13 AM	Rate (0)
MinhMM Posts: 9 Rating: (0)	My system include PLC S7 300, Masterdrives VC connected via Profibus. My Masterdrives was broken and i replaced by the new one. I downloaded the parameters from my laptop to the CUVC, everything is OK. But when I operate the system, the Masterdrives appears fault F006 "DC link overvoltage". I read the manual and increase the deceleration time but the Masterdrives still has that fault. Please show me the solutions for this fault. Thanks and regards!
MinhMM Posts: 9 Rating: (0)
Suggestion To thank Quote Answer

6/26/2012 3:41 PM	Rate (0)
Gary.Hare Posts: 101 Rating: (8)	Does this occur when you decelerate? For high inertia loads you will need some form of regeneration or a brake chopper and resistor. Have these been reconnected if you had them?
Gary.Hare Posts: 101 Rating: (8)
Suggestion To thank Quote Answer

6/27/2012 4:19 AM	Rate (0)
MinhMM Posts: 9 Rating: (0)	Gary.Hare Does this occur when you decelerate? For high inertia loads you will need some form of regeneration or a brake chopper and resistor. Have these been reconnected if you had them? Thanks for your reply, My system has all of those. When I replace the new CUVC by the old one, the system operate normally. This problem occurs when i acceleration. Are there any parameters to adjust the braking usage ratio ( as HITACHI inverter)?
MinhMM Posts: 9 Rating: (0)
Suggestion To thank Quote Answer

6/29/2012 11:20 AM	Rate (0)
Gary.Hare Posts: 101 Rating: (8)	Very strange for this to occur when accelerating!!!!
Gary.Hare Posts: 101 Rating: (8)
Suggestion To thank Quote Answer

8/18/2015 1:48 PM	Rate (0)
Min_Moderator Posts: 4757 Rating: (122)	New question published by AutoGen_775500 is split to a separate thread with the subject old cuvc card failure f006 and f011. Best regards Min_Moderator
Min_Moderator Posts: 4757 Rating: (122)
Suggestion To thank Quote Answer

Share this page:

Share this page on...