10/28/2016 3:40 PM | |
Posts: 2 Rating:
|
Dear , we also have the same problem , after TDS motor burned out and complete system went "black" ( all generators stopped ) TDS type : DQ70BSC (Beijing Petroleum Machinery Factory) After restart , the interface LED's didn't light up any more we replaced the the old Control-CUR Q6VN608012 C98043-A1580-L1 15 with the (Written on the box: 6SE7090-0XX85-1DA0) new Control-CUR Q6T5391565 C98043-A1680-L1 13 the new board was supplied without E-prom , so we install the old E-prom from the old board chip info: V98113-A1680-A1 4.8 Now the interface shows 2 blinking lights (red&green) the PMU shows code F060 and is not responding on the push-buttons as we where adviced the New CUR card maybe not working correct , I found an other new (boxed) CUR6SE7090-0XX85-1DA0 , and an pre installed EPROM V4.8 , after install this one , first Code F041 showed up and direct code F060 again , also no responce on the pushbuttons on the PMU again..... as I,m not an expert, and all trained personal left the Project , maybe somebody can provide me the step by step moves to get the drilling rig back in biz Ps: as the old crew took all information we are floating in the dark...... Also we need to recover the log-in/password for the computer system (WINCC software) any suggestions? Thanks up front for your support Rene Kwakkel ------------------------------------------------------------------------------------------ |
Last edited by: Min_Moderator at: 10/31/2016 2:00:35 PMNew subject after splitting Last edited by: Rene Kwakkel at: 11/1/2016 10:56:47 AM |
|
Follow us on