4/24/2016 9:02 PM | |
Joined: 8/16/2010 Last visit: 7/25/2024 Posts: 636 Rating:
|
Hi all again. Is there any way to set calibration 0 weight value, and calibration 1 weight value and then transfer DR3 to SIWAREX module? Thank's a lot. ------------------------------------------------------------------------------------------ |
Last edited by: Blue Moderator at: 4/25/2016 8:08:37 AMNew subject after splitting |
|
4/25/2016 9:07 AM | |
Joined: 3/17/2013 Last visit: 8/25/2024 Posts: 481 Rating:
|
Hi Hope this link helps. https://cache.industry.siemens.com/dl/files/348/26624348/att_83076/v1/siwarex_ms-en.pdf On Page 10 explained with examples Vijay |
Last edited by: N. Vijay at: 4/25/2016 9:09:37 AM |
|
4/25/2016 10:03 AM | |
Posts: 206 Rating:
|
Hi Milosh,
if you have a Siwarex WP231 you can look to the QuickGuide https://support.industry.siemens.com/cs/ww/en/view/73517989 There it is explained how to do the calibration. Regards ABenno |
4/25/2016 4:15 PM | |
Joined: 10/10/2010 Last visit: 4/28/2024 Posts: 307 Rating:
|
you can use the SIWAREX software package for scaling and calibration after reading the manual |
Follow us on