Hi,

Is there any way to run 1FT5  1FT6 1FK6  1FK7 servo motors connected with  6SN1123 LT modules + 6SN1118 drive Control cards without any SIEMENS CNC controllers.

Thanks

------------------------------------------------------------------------------------------
Split from Control Simodrive 611 without siemens hardware.

 yes--using 6SN1118-1NH01-0AA1 control card. for 1ft6, 1fk6,1fk7 motor--support by SIMOCON U SW

AND USE 6SN1118-0AA11-0AA1 CONTROL card for 1ft5 motor --NO need any sw.

PM me for more detail, --I have all those motor, control cards and drives

and almost test them everyday.

Controls_Engineer6SN1118-0AA11-0AA1

Hi,

Is there any way to run 1FT5  1FT6 1FK6  1FK7 servo motors connected with  6SN1123 LT modules + 6SN1118 drive Control cards without any SIEMENS CNC controllers.

Thanks

------------------------------------------------------------------------------------------
Split from Control Simodrive 611 without siemens hardware.

 Can you tell me the name of the manuals throught which we can configure those drives PLZ.

nulizhang

 yes--using 6SN1118-1NH01-0AA1 control card. for 1ft6, 1fk6,1fk7 motor--support by SIMOCON U SW

AND USE 6SN1118-0AA11-0AA1 CONTROL card for 1ft5 motor --NO need any sw.

PM me for more detail, --I have all those motor, control cards and drives

and almost test them everyday.

Controls_Engineer6SN1118-0AA11-0AA1

Hi,

Is there any way to run 1FT5  1FT6 1FK6  1FK7 servo motors connected with  6SN1123 LT modules + 6SN1118 drive Control cards without any SIEMENS CNC controllers.

Thanks

------------------------------------------------------------------------------------------
Split from Control Simodrive 611 without siemens hardware.

 

For other motor you listed--see my attached picture

contact me for real set up test bench--as you will see when you find book, you will no idea from where to do the basic--for me they are all small cake, special for 1FT5 motor, i worked in that Siemens drive factory for 6 month

1FT6034-1AK71-4AG1 [2NM]

1FT6044-1AF71-4AG1 [5NM]

These are the motors we are planning to use in simodrives without  CNC controller.

 Your motor are small and medium size, you need following:

HW--

6SN1146-1AB00-0BA1

--6SN1146--1AB00-0BA1----611 POWER SUPPLY MODULE

--6SN1123-1AB00-0BA1--611 double axis drive module (or call power section of drive)

--6SN1118-1NH01-0AA1 control card --611U position control card, you can use it programming    movement as you want--linear , 2 axis , but no interpolation 

--motor power cable

--motor encoder cable (6fx2002-2ca31-xxxx) --you have increamental encoder

SW--

Siemens SIMO COM U software, install in a Laptop or PC and communication cable 

------------------------

for detail how to set up, how to make 611U axis programming  or purchase hardware, you can contact me by PM, 

augt

1FT6034-1AK71-4AG1 [2NM]

1FT6044-1AF71-4AG1 [5NM]

These are the motors we are planning to use in simodrives without  CNC controller.