I'm deploying a web using AWS analog readings works fine but switches won't activate my digital outputs  

Dan-Cuspi

I'm deploying a web using AWS analog readings works fine but switches won't activate my digital outputs  

Hi,

what is your cloud data table configuration for the switch? If you have configured that the signal is only send once a minute, then you have to wait ~1 minute to get it updated.

However: You can go to your AWS accont and open the shaddow of your Iot device. Then press the buttom and check. In AWS IoT shadow of the IoT device if the data is configured right you should see the change very quickly compared to the resalt in the dashboard. The reason is, that multible delay may happen:

1. dependency according you AWS data table configfuration (On change or frequency)
2. data transver from IoT device to AWS shadow
3. In AWS from IoT shadow to E2C
4. From E2C to elasticbeastalk service
5. From Elasticbeanstalk to dashboard

And don't forget: Never compare a AWS dashboard reaction with a HMI connected directly to LOGO!. 

Hope this helps

Hi, when I click on the switch it adds desired with the Q2 in the shadow monitor:

{    

    "desired": {            <-----
       "Q..1:2-1": "01"​     <-----
     }                      <-----

   "state": {
    "reported": {
       "AM..4:1-1": "0000",
       "AM..4:2-1": "017E",
       "I..1:1-1": "00",
       "Q..1:2-1": "00"
     } 
   }
}

 But nothing changes on the plc. The switches are configured with on change option