4/2/2016 8:42 PM | |
Posts: 12 Rating: (0) |
Dear sir, firstly i have problem with the 840D ( HMI ) no data appears on the screen only lit up secondly the statues of 573.2 ( 7 segment = 6 ) that means NCK software is initialized. the leds statues as the following :- PF : on PS : flashes then i read that general rest is required so i turned switch 4 to position 3 then to 0 this action make the NCU to be run but when i switched off the power it returns to stop again so please tell me how can start this machine what is required software , cables kindly check the attached photos thank you waiting your reply ASAP
Attachment20160402_132546.zip (66 Downloads) |
Last edited by: BnaguibWadie at: 4/2/2016 8:46:00 PM |
|
4/4/2016 9:39 AM | |
Joined: 9/3/2014 Last visit: 3/13/2019 Posts: 4771 Rating: (123) |
New question published by THIRUVARUL is split to a separate thread with the subject CNC LATHE (siemens 840D), new outer diameter grooving cycle. Best regards |
4/5/2016 7:16 PM | |
Joined: 9/3/2014 Last visit: 3/13/2019 Posts: 4771 Rating: (123) |
New question published by THIRUVARUL is split to a separate thread with the subject 840D, write this condition in programme. Best regards |
Follow us on