SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

S7-1200 motion control

3/9/2013 12:55 PM	Rate (0)
Lambda Posts: 4 Rating: (0)	Hi everyone I'm using CPU 1212C DC/DC/DC. I'm trying to get the axis enabled using MC_POWER instruction but it doesn't work. I set %Q0.5 as DRIVE ENABLE output but it doesn't work when the MC_POWER instruction is used. I followed all the configuration steps in S7-1200 manual. Am I missing something? Thanks for your help Attachment 1.jpg (950 Downloads)
Lambda Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

3/9/2013 9:10 PM	Rate (0)
Denilson Pegaia Diamond Member Joined: 9/23/2005 Last visit: 12/28/2025 Posts: 4434 Rating: (1487)	Hi, what do you see on the power block output's?
	Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer

3/9/2013 9:40 PM	Rate (0)
Lambda Posts: 4 Rating: (0)	Thanks for your help. I have just found the solution.
Lambda Posts: 4 Rating: (0)
Suggestion To thank Quote Answer

3/10/2013 8:28 AM	Rate (1)
umencho Grandmaster Joined: 3/21/2006 Last visit: 10/16/2025 Posts: 10239 Rating: (1183)	Lambda Thanks for your help. I have just found the solution. Please, share it with us! Thank you! Best regards, Hristo Mihalev

Suggestion To thank Quote Answer
This contribution was helpful to 2 thankful Users Tomy Master Mo.Sa

7/8/2013 11:18 AM	Rate (0)
O_Moderator Diamond Member Joined: 4/24/2009 Last visit: 8/20/2024 Posts: 2682 Rating: (135)	Follow-up question was splitted to parameterization of the pulse generator (PTO) Best regards O_Moderator
	Tips&Tricks for the forum usage
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users Mo.Sa

4/28/2014 8:17 AM	Rate (0)
GrasserF Posts: 340 Rating: (6)	new question is splittet to I am getting problem with the change in direction for stepper motor (1215C, Step 7 Basic V11).
GrasserF Posts: 340 Rating: (6)
Suggestion To thank Quote Answer

3/25/2015 11:29 AM	Rate (0)
Min_Moderator Posts: 4758 Rating: (122)	New question published by Yogesh Purohit is split to a separate thread with the subject 1214C, is There Any Limitation of No. of Motion Control Blocks?. Best regards Min_Moderator
Min_Moderator Posts: 4758 Rating: (122)
Suggestion To thank Quote Answer

Share this page:

Share this page on...