End of NC program 808D

Good day,

my question is:

I want control 808D over inputs and outputs from other PLC S7-300.

If I started the NC program by DB3200.DBX7.1 I need from 808D have output signal about end of the program.

Is here some register/bit which can say me, that program was fineshed after starting?

Thank you very much for answers

Jan Traspe

Hello,

What do you want?

Do you want to control 808D by PLC or you want to control PLC by 808?

NC program by DB3200? what you want? Run part program or want to check logic?

Dear 

just set a output with the DB2500.DBX1003.6 (m30) & take this output as a input for program end

and reset this output with cycle start

If problem get solve please let us know how it is?

Dear Mr. Rajni,

Thank you very much. I think that your answer is very helpfull for me. I think that this solve my problem, tomorrow I will test it.

Thank you so much

Dear Rajni,

thank you for your help. This is what I need :) Now I am using DB2500.DBX1003.6 which is set to ON after finished the program. This bit I am using for setting my output (input of ths S7-300).

Thank you very much

Using M30  is good suggestion and you already tested --working OK, and now we know what you want to control. DB2500.DBX1003.6--(M30) is in 808D, M30 is a old topic of Siemens CNC, we use it as sign of NC program end--( can be used set parts counter) From SINUMERIK 800 system to 840C and 840D/810D.The different is old 800 system M function is stored in Flag area(840C in S5 DB) while after 840D, M function stored in DBxxx. (channel DB). one remind is don't forget M02, it is Main program end as well, you can use PLC "OR" function to make M30 or M02 both working.

Jan Traspe

Dear Rajni,

thank you for your help. This is what I need :) Now I am using DB2500.DBX1003.6 which is set to ON after finished the program. This bit I am using for setting my output (input of ths S7-300).

Thank you very much

New question published by AutoGen_4133986 is split to a separate thread with the subject Error in 808D, internal communication between the panel and NCK canceled.

Best regards
Min_Moderator