Hi guys :)

When I open my ProTool (just installed, V5.2+SP2), I get the following error:

'The procedure entry point COMResModuleInstance could not be located in the dynamic library COMRes.dll'. What does this mean? What should I do?

I already tried to install later versions of ProtOOL (V6.0; V5.1) and that didn't work also...

Thanks in advance!! :)

Hello,

if you click OK to all messages, probably program will working. try it and give info pls.

What Windows Version?

V5.x is only usable until W2k.

For Windows XP you need V6.0 SP3.

Hello,

check pls for sure this:

Observe the system requirements for ProTool
The system requirements for ProTool are given in the document "installnotes.pdf" on the ProTool Installation CD ("...\Docs\ProTool\English\").

New question published by mr.adi is split to a separate thread with the subject How to configure ALARM MESSAGE on ProTool?.

Best regards
Min_Moderator