------------------------------------------------------------------------------------------
Split from ProTool error.

Hello

Pl follow the following procedure to configure alarm Messeges in Protool.

1. In Protool -> Interface Area -> Define Interface areas for Alarm Messages and if required Event Messeges also and create and assign corresponding DBs in the PLC.

2. Define Messages -> Alarm / Event Messages. -> Protool automatically assigns the trigger bit of each msg ( Displayed in the Bottom right corner ).

3. Now if one or more trigger bit(s) is high in PLC, the corresponding alarm will be displayed in a compiled and activated project.

Hope this helps

Cheers
Navnag

New question published by falah ahmad is split to a separate thread with the subject protool project for push button configure with light.

Best regards
CS Moderator