Bismillah

I will to try make a simulation used siemens LOGO, i made a program for up and down data used combination the timer and the counter instructions, how to save data in "cnt/counter"?

i attached the screenshoot image.

thank all.

Hi.

Perhaps this solution will be useful for solving your problem.

Go with your mouse to the counterblock

Click with the right mousebutton

Go to Blockproporties.

In the bottom there is a box "Retentivy" click it ON

Thats all, good luck

Hi, Toeternietoe

Topic starter  installed In the bottom part there is a window "Retentivy" click on it ON. This can be seen in the picture (Rem = on). 

New question published by Siemens Logo PLC is split to a separate thread with the subject Forget password.

Best regards
Min_Moderator

edwin saputra

Bismillah

I will to try make a simulation used siemens LOGO, i made a program for up and down data used combination the timer and the counter instructions, how to save data in "cnt/counter"?

i attached the screenshoot image.

thank all.

Hello.

I have replicated your program and see no problem in the simulation (LSC V8.1). The program will not load to the LOGO device - the output of the count block needs to be terminated to an X / M / Q.

Bye.
- Dan

Hi.

I corrected my diagram taking into account the output of the data to the analog output, analogue flag, analog output network output. You can use the counter value as a reference in the parameters of other blocks (in the example I used the counter value in the mathematical calculation block). In order for the value to be always displayed on the HMI panel, the block of mathematical values ​​must always be active.