Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

810D - Drive Bus Hardware Fault - Error 300200

Created by: jgreenwood at: 3/11/2006 2:44 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

3/11/2006 2:44 PM	Rate (0)
jgreenwood Posts: 1 Rating: (0)	I recently purchased a machine with an 810D controller at acution. I am getting a Drive Bus Hardware Fault - Error 300200. I have checked all of the cable connections. Cleaned them. I have also replaced the drvie terminator and tried different cables. We had to replace the 24v power supply when we received the machine. The machine had been sitting for about a year. I am thinking this might be a battery problem. Any suggestions or comments. The error seems to go away after the machine has been powered up for a full day and then re-started. HELP!
jgreenwood Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

3/12/2006 3:55 AM	Rate (0)
tomas94 Experienced Member Joined: 10/2/2005 Last visit: 3/2/2021 Posts: 24 Rating: (0)	I don’t know if you already have tried this, but check the small flat cables between the drives again. Regards Tomas[:)]

Suggestion To thank Quote Answer

3/14/2006 3:34 PM	Rate (0)
SteveJ Posts: 328 Rating: (29)	Hi Mr Greenwood I would need to know a little more about the configuration of your machine, are any other alarms present? is there any device connected to the drive bus, maybe DMP interface? Best regards SteveJ
SteveJ Posts: 328 Rating: (29)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on