Navigation

S7-200 SMART with V20(Modbus)

Created by: Josh Elliott at: 11/26/2014 11:18 AM (1 Replies)

Posts: 204

Rating:

(29)

Hi,

Taking the following example you can setup a simple MODBUS master-slave communication between s7-200 SMART and Sinamics v20.

Note:Find the Sample Program in the attachment.

Requirement:
To operate the MODBUS protocol you must first procure and install first the STEP7Micro/WINSMART

Parameter matching
For MODBUS communication, on the master side you need library blocks "MBUS_CTRL" and "MBUS_MSG"

MBUS_MSG

Parameter	Meaning	Selection options
EN	Release
First	Activation
Slave	Slave address
RW	"Read" or "Write"	0=read, 1=write
Addr	MOBDUS initial address	0 .. 128 = digital outputs Q0.0 .. Q15.7 10001 .. 10128 = digital inputs I0.0 .. Q15.7 30001 .. 30092 = analog inputs AIW0 .. AIW62 40001 .. 49999 = holding register²
Count	Number of bits (0xxxx, 1xxxx) / words (3xxxx, 4xxxx)
DataPtr	Pointer to start of variable memory
Done	'Finished' message
Error	Error code	¹⁾

MASTER

MBUS_CTRL

Parameter	Meaning	Selection options
EN	Release
Mode	Protocol specification	0=PPI, 1=MODBUS
Baud	Transmission rate in kbps	1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
Parity	Parity	0=none, 1=odd, 2=even
Timeout	Maximum time in ms for the slave's response
Done	'Finished' message
Error	Error code	¹⁾

MODBUS V20.zip (2664 Downloads)

4 thankful Users

11/27/2017 6:58 AM	Rate (0)
CHAUHAN'S Regular Member Joined: 11/6/2012 Last visit: 11/7/2024 Posts: 3 Rating: (0)	Sir please clear me the which one bit will give the start command And which one address we will give the frequency?

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users engineer singh saab

Share this page:

Share this page on...