Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

"Alerm view" set "alarm events" but alarm will apper if from 0 to 1 and if from 1 to 0.

Created by: Hasic.bad at: 9/8/2017 6:39 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

9/8/2017 6:39 PM	Rate (0)
Hasic.bad Posts: 7 Rating: (0)	i have the same problem "Alerm view" set "alarm events" but alarm will apper if from 0 to 1 and if from 1 to 0. I need track the same alarm several times. Your link "wizard" did not help. ------------------------------------------------------------------------------------------ Split from how to see historical alarm in win cc flexible run time.
Hasic.bad Posts: 7 Rating: (0)	Last edited by: The Helping Hand at: 9/11/2017 9:06:52 AM New subject after splitting
Suggestion To thank Quote Answer

9/12/2017 10:02 AM	Rate (0)
Murof Platinum Expert Joined: 8/3/2009 Last visit: 12/19/2024 Posts: 14458 Rating: (1806)	Hello Hasic.bad In the Alarmbuffer and Alarmlog - View in the Alarmview or Alarmwindows you always see every alarm Event. There are these alarm events: -> Incoming (rising edge) -> Outgoing (falling edge) -> Achnowledged (Acknowledged in HMI) in the mentioned views you see every event not just the incoming. If this is not your Question then please describe a little bit more exactly. Bye Murof
	If this Information really helps, you could use the Rate function
Suggestion To thank Quote Answer

9/12/2017 1:59 PM	Rate (0)
Hasic.bad Posts: 7 Rating: (0)	I have "alarm view" setting on "event alarm" but this setting does not allow setting -> Incoming (rising edge) -> Outgoing (falling edge) -> Achnowledged (Acknowledged in HMI) and the LOG function can not be enabled for TP177A. I need to tell the incoming event only before I resolve the TP panel, in about 8 hours the message will disappear.
Hasic.bad Posts: 7 Rating: (0)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on