How to set DB210 to zero?

Hi   can anyone tell me how to set my DB210 to zero,  it has 214 words     

I found this here......

L 0
T #t_ZERO                         <---- What do I set here

CALL SFC21
BVAL := t_ZERO             <----- and here
RET_VAL := MW255
BLK := P#DB2.DBX0.0 WORD 300

any help would be greatly appreciated   

------------------------------------------------------------------------------------------
Split from reset to zero db.

kegs

Hi   can anyone tell me how to set my DB210 to zero,  it has 214 words     

I found this here......

L 0
T #t_ZERO                         <---- What do I set here

CALL SFC21
BVAL := t_ZERO             <----- and here
RET_VAL := MW255
BLK := P#DB2.DBX0.0 WORD 300

any help would be greatly appreciated   

 Hello Kegs.

Bval is the value or description of the area whose contents will be used to initialize the destination area (source area), so is a memory area, ANY datatype. They are transferring the zero value to the memory area. BVAL parameter is of datatype ANY you can't just write a value there because the block requires a memory area. So first set the value you want to the memory area and then copy the value of memory area,source area, to BLK, destination area.

Sorry for not being better explaining, my English is not so good I guess but I hope this helps you to understand a little bit more.

Regards.

kegs

Hi   can anyone tell me how to set my DB210 to zero,  it has 214 words     

,,,
BLK := P#DB2.DBX0.0 WORD 300

BLK := P#DB210.DBX0.0 WORD 214