Hello all,

I am trying to simulate my project but I get the following error:

I turned on "Support simulation during block compilation" in the project properties. The blocks generating an error when downloading are not know-how protected. In another topic I read the following: "In the block property page "can be simulated with..." is just an indicator to see if the block has the binary for simulation. It is not operatable". This option is not checked in my project.

I can work around this issue by editing all my library blocks, but many blocks are dependent on other blocks, so this will be very time consuming and prone to errors.

Is there another solution on how to get my blocks into simulation? 

Hello,

you need also the hook at "Can be simulated with PLC-Sim"
"Normally" are all library blocks not prepared for simulation.

Then must you compile this function again.

regards
CaOd

CaOd

Hello,

you need also the hook at "Can be simulated with PLC-Sim"
"Normally" are all library blocks not prepared for simulation.

Then must you compile this function again.

regards
CaOd

 Thank you for the answer, but it is not possible to hook this function..

I just had the same issue.

I terminated the connection to the library, then recompiled the block.

I was now able to check the box "Can be Simulated...."

Added the block back to the library.

Not a great fix but it worked.

Hi,

go through below link, it solution best solution for you.

109754928

Anklesh

Hi,

go through below link, it solution best solution for you.

109754928

It helped a lot. Thank you.