Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Connection loss by IP change

Created by: domjaw at: 7/12/2017 3:22 PM (17 Replies)

Rating (0)

Thanks 2

Result pages:: |; 1 | 2; |

18 Entries

Entries per page: 10 | all

7/19/2017 9:44 AM	Rate (0)
bergmanu Platinum Expert Joined: 4/28/2015 Last visit: 1/22/2020 Posts: 1226 Rating: (199)	Then please try to add the line: nameserver 192.168.120.1 Of course the IP address is the router's. Best regards!

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users domjaw

7/19/2017 10:20 AM	Rate (0)
domjaw Member Joined: 5/23/2017 Last visit: 7/25/2017 Posts: 10 Rating: (0)	By adding the IP it deletes it automatically. So when I reboot and check the file the new IP is gone.

Suggestion To thank Quote Answer

7/19/2017 10:32 AM	Rate (0)
bergmanu Platinum Expert Joined: 4/28/2015 Last visit: 1/22/2020 Posts: 1226 Rating: (199)	Please try the steps describes in this post.

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users domjaw

7/19/2017 12:12 PM	Rate (0)
domjaw Member Joined: 5/23/2017 Last visit: 7/25/2017 Posts: 10 Rating: (0)	/etc/resolv.conf now Looks like this: domain <Name> nameserver 192.168.120.1 But by pinging anything it says bad ping..

Suggestion To thank Quote Answer

7/19/2017 1:36 PM	Rate (0)
DevGuy Advanced Member Joined: 4/28/2015 Last visit: 9/12/2017 Posts: 40 Rating: (2)	just to be sure: is there still a hashtag (#) at the beginning of the line with the address of eth1 in your "interfaces" file??

Suggestion To thank Quote Answer

7/19/2017 2:54 PM	Rate (0)
domjaw Member Joined: 5/23/2017 Last visit: 7/25/2017 Posts: 10 Rating: (0)	DevGuy just to be sure: is there still a hashtag (#) at the beginning of the line with the address of eth1 in your "interfaces" file?? No. But now both of my cases do not work anymore.

Suggestion To thank Quote Answer

7/20/2017 9:25 AM	Rate (0)
bergmanu Platinum Expert Joined: 4/28/2015 Last visit: 1/22/2020 Posts: 1226 Rating: (199)	Can you reinstall your image on the SD card? In a few cases after installing the example image again the problem was solved. It's woth a try..

Suggestion To thank Quote Answer

7/25/2017 3:13 PM	Rate (0)
domjaw Member Joined: 5/23/2017 Last visit: 7/25/2017 Posts: 10 Rating: (0)	A new Installation has not solved the Problem. Now I'm trying it with a Switch. Is there a correct way how to configure the eth1 port for this case? Just writing dhcp gives me no connection to my simotion.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

Follow us on