Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

G120 connecting with PC via Profinet

Created by: AdasK at: 11/7/2016 12:57 PM (15 Replies)

Rating (1)

Thanks 2

Result pages:: |; 1 | 2; |

16 Entries

Entries per page: 10 | all

11/8/2016 2:28 PM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 1/25/2021 Posts: 18765 Rating: (2345)	yep

Suggestion To thank Quote Answer

11/8/2016 2:35 PM	Rate (0)
AdasK Posts: 72 Rating: (1)	I assigned IP address to the G120 before. I cliked on "Update acessible devices" and what I see is on attachment. I still cant go online Attachment attachment3.png (61 Downloads)
AdasK Posts: 72 Rating: (1)	Last edited by: AdasK at: 11/8/2016 2:37:22 PM
Suggestion To thank Quote Answer

11/8/2016 2:46 PM	Rate (1)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 1/25/2021 Posts: 18765 Rating: (2345)	Hello, no you have projected (configured) the IP on the device in the project! But in the list of accessible Nodes you see only the MAC and no IP. So the device have online no IP. Select the entry with the MAC Adress, open Online&Diagnostics -> functions -> set IP Adress Set the IP you sepcified in the project (192.168.0.1) an set it on the Online device, now you should be able to go online! Regards Christoph

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users AdasK

11/8/2016 2:58 PM	Rate (0)
AdasK Posts: 72 Rating: (1)	Whhoooho! Thank very much, Friends. Everything is fine after I properly (according to your advices) enter the device's IP address. Thank you so much and sorry for my awkwardness. I have one more question: Is it possible to have in the tree only one device without this Unassigned devices ? I understand that this the same device, but it would look better maybe
AdasK Posts: 72 Rating: (1)
Suggestion To thank Quote Answer

11/8/2016 3:03 PM	Rate (0)
ChristophD Grandmaster-Expert Joined: 5/12/2006 Last visit: 1/25/2021 Posts: 18765 Rating: (2345)	Hello, if you have a PLC in the project which control the G120 then you assign the G120 device in the network view to it, then the "unassign" should go away. Regards Christoph
	Last edited by: ChristophD at: 11/8/2016 3:04:08 PM
Suggestion To thank Quote Answer

11/8/2016 3:13 PM	Rate (0)
AdasK Posts: 72 Rating: (1)	Thank you so much again for your every important answer. I really appreciate it. Best regards, Adam
AdasK Posts: 72 Rating: (1)
Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Related topics by keywords:

Follow us on