Industry Online Support
Technical Forum
2/8/2013 7:04 AM | |
Posts: 241 Rating: (50) |
Hello All I am comissioning G130 PM240--6SL3224-0XE41-3UA0, i.e without built in choopper And i am using braking unit - 6SL3100-1AE31-0AB0 Problem is that whenever i give enable signal to chopper to X21.1 drive stops on DC link overvoltage fault and P1240=0. But if i make P1240=1 and not giving enable signal to x21.1 , precharging resistor is blown once. parameters attached here what do I do then??? AttachmentPolycab.zip (111 Downloads) |