PG/PC interface still missing

ChristophD

Hello,

you can try this:
delete the Folder /ProgramData/siemens/automation/Simatic OAM/data (ProgramData is a hidden folder, you must enable the show hidden Folders option in Windows Explorer)

Open a cmd Shell with adminstrator rights (cmd -> Run as Administrator)

type s7epaIMP64x.exe in the Admin shell.

Regards
Christoph

 Hi Guys,

Please help me, i got same problem. i'm use Step7 v5.5 on Windows 7 64 bit i have try to delete folder "data" and run s7epaimp64x.exe on cmd shell as administrator, but on PG/PC interface still missing. any solution for this. Thanks for your help.

regards,

------------------------------------------------------------------------------------------
Split from PG/PC interfaces missing.

abu hanif

 

ChristophD

Hello,

you can try this:
delete the Folder /ProgramData/siemens/automation/Simatic OAM/data (ProgramData is a hidden folder, you must enable the show hidden Folders option in Windows Explorer)

Open a cmd Shell with adminstrator rights (cmd -> Run as Administrator)

type s7epaIMP64x.exe in the Admin shell.

Regards
Christoph

 Hi Guys,

Please help me, i got same problem. i'm use Step7 v5.5 on Windows 7 64 bit i have try to delete folder "data" and run s7epaimp64x.exe on cmd shell as administrator, but on PG/PC interface still missing. any solution for this. Thanks for your help.

regards,

 check the s7epaimp64x logfile for any error message

Hello  everyone,

facing the same situation of having no PG/PC Access points. I followed ChristopD's steps of deleting the data files, rebooting and running s7epaimp64x.exe, without success. 

Here is an overview of what I have. I am considering reinstallation of TIA, since a restore is not a viable option. Should that restore the PG/PC issue though?

Thanks for your input.

Hi,

from the log in the picture is looks that the needed templates are not installed correctly on the system.

A repair install can potential fix this problem, but is must not fix it.

Regards

Christoph

Thanks for your quick response.

Too bad about the templates.

The setup dialogue for TIA v14 only allows for deinstallation, no reparation or changes options appear anywhere. It seems like I will really have to reinstall completely.

New question published by emergala78 is split to a separate thread with the subject Is there no way to reinstall only the PG / PC interface?.

Best regards
The Helping Hand

Dear ChristophD

There's no error message on log file, may you can help me 

ChristophD

 

abu hanif

 

ChristophD

Hello,

you can try this:
delete the Folder /ProgramData/siemens/automation/Simatic OAM/data (ProgramData is a hidden folder, you must enable the show hidden Folders option in Windows Explorer)

Open a cmd Shell with adminstrator rights (cmd -> Run as Administrator)

type s7epaIMP64x.exe in the Admin shell.

Regards
Christoph

 Hi Guys,

Please help me, i got same problem. i'm use Step7 v5.5 on Windows 7 64 bit i have try to delete folder "data" and run s7epaimp64x.exe on cmd shell as administrator, but on PG/PC interface still missing. any solution for this. Thanks for your help.

regards,

 check the s7epaimp64x logfile for any error message