Skip to Content

support.automation.siemens.com | Technical Forum | Sunday, December 15, 2019 12:00:16 PM

Pin Out cable Adapter 5511

Created by: gcatuogno at: 11/24/2006 3:57 PM (3 Replies)

Rating (0)

Thanks 0

4 Entries

11/24/2006 3:57 PM	Rate (0)
gcatuogno Member Joined: 11/24/2006 Last visit: 12/7/2006 Posts: 2 Rating: (0)	Hello, I have the CP5511 Adapter for my notebook but I dont have the cable to comunicate with PLC,, thi cable is DB9 both sizes, Anyone now PinOut of this cable?? Thanks

Suggestion To thank Quote Answer

11/24/2006 4:29 PM	Rate (0)
Wizard Diamond Member Joined: 4/24/2006 Last visit: 12/13/2019 Posts: 7442 Rating: (893)	Hello, Here is a link to manual: http://support.automation.siemens.com/WW/view/en/13654593 See page 48 of PDF Best regards, Wizard

Suggestion To thank Quote Answer

11/27/2006 3:49 PM	Rate (0)
gcatuogno Member Joined: 11/24/2006 Last visit: 12/7/2006 Posts: 2 Rating: (0)	Ok.thanks, so the cable have to be pin 1 --> pin 1 pin 2 --> pin 2 pin 3 --> pin 3 pin 4 --> pin 4 pin 5 --> pin 5 pin 6 --> pin 6 pin 7 --> pin 7 pin 8 --> pin 8 pin 9 --> pin 9

Suggestion To thank Quote Answer

11/27/2006 4:03 PM	Rate (0)
Wizard Diamond Member Joined: 4/24/2006 Last visit: 12/13/2019 Posts: 7442 Rating: (893)	Hello, I'm not so sure about that. If I look at pin 4 its a input signal and pin 9 is a output signal. Perhaps there are other users who can help? Best regards, Wizard

Suggestion To thank Quote Answer