Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

portal 11

Created by: Rudrani at: 3/28/2012 6:09 PM (4 Replies)

Rating (0)

Thanks 0

5 Entries

3/28/2012 6:09 PM	Rate (0)
Rudrani Experienced Member Joined: 3/28/2012 Last visit: 6/13/2018 Posts: 163 Rating: (4)	hello sir/mam, i am using TIA PORTAL 11. I am using a memory card of 2MB. My program contains PID controller block. I copied the program in memory card but when i insert the memory card in CPU , it goes into stop mode and when i copied program without PID controller, CPU goes in run mode.Please tell me the settings that i should do while using PID controller......

Suggestion To thank Quote Answer

3/29/2012 12:27 PM	Rate (0)
Denilson Pegaia Platinum Expert Joined: 9/23/2005 Last visit: 11/11/2019 Posts: 3745 Rating: (1032)	Hi, Can you send us the diagnosti buffer of your S7-1200 when it doesn't starts?
	Denilson Pegaia Siemens Industry Sector Technical Support
Suggestion To thank Quote Answer

3/30/2012 6:42 AM	Rate (0)
Rudrani Experienced Member Joined: 3/28/2012 Last visit: 6/13/2018 Posts: 163 Rating: (4)	Respected Sir, Please check the attached file of diagniostic buffer of my program...... and thanks for considering my problem..... Attachment Diagnostic buffer.zip (9 Downloads)

Suggestion To thank Quote Answer

3/30/2012 8:28 AM	Rate (0)
Cicero Gold Member Joined: 10/10/2005 Last visit: 9/30/2019 Posts: 1388 Rating: (84)	Hello, if you insert the PID blocks in your program, then compile the complete project again (Compile > All) bevor you copy the program on the memory card. After do the power off, insert the memory card in the CPU and do the power on again. Check also the firmware of your CPU and if possible make an update of the firmware your CPU. With best regards Cicero

Suggestion To thank Quote Answer

3/30/2012 11:38 AM	Rate (0)
Rudrani Experienced Member Joined: 3/28/2012 Last visit: 6/13/2018 Posts: 163 Rating: (4)	Thank you so much sir.....

Suggestion To thank Quote Answer

| |

Follow us on