7/4/2011 8:36 PM | |
Posts: 55 Rating: (0) |
Yes. Before we start to replace we make fotos how it was connected. |
7/5/2011 7:10 AM | |
Posts: 2964 Rating: (478)
|
Hello, Any error are you getting on 611U card ? Does it show RUN indication on this. Check this link: Clearing NC-PLC archive: Creating NC-PLC archive: /tf/WW/en/Posts/47309 |
7/5/2011 8:12 AM | |
Posts: 55 Rating: (0) |
Thanx EKALAVYA for your replies. So all i need to now - clear NC PLC and load archives (we have 2001 year NC/PLC archives from manufacturer)? |
7/5/2011 8:22 AM | |
Posts: 55 Rating: (0) |
We also have 611U_11a.par and UPG_ausl.arc files. It also must be used or not? |
7/5/2011 10:33 AM | |
Posts: 2964 Rating: (478)
|
CLEAR YOUR NC-PLC AND LOAD YOUR ARCHIVE BACKUP THAT IS SUFFICENT.... |
7/5/2011 3:52 PM | |
Posts: 55 Rating: (0) |
This is all we have. i try many of them. Nothing change. AttachmentARC.DIR.zip (556 Downloads) |
7/6/2011 7:27 AM | |
Posts: 55 Rating: (0) |
non actual |
Last edited by: Akifiev at: 7/6/2011 10:13 AMLast edited by: Akifiev at: 7/6/2011 7:28 AM |
|
7/6/2011 12:08 PM | |
Posts: 2964 Rating: (478)
|
Hello, Check this link : /tf/WW/en/Posts/60245#top may be useful.... Regards, Ekalavya |
7/6/2011 7:35 PM | |
Posts: 55 Rating: (0) |
we have 8A LT module from right side of CCU connected to CCU and it have number 6SN1123-1AA00-0HA1 |
7/6/2011 8:04 PM | |
Posts: 55 Rating: (0) |
Ok i try tomorrow and write back asap |
7/6/2011 8:21 PM | |
Posts: 2964 Rating: (478)
|
Hello.. You need to go to drive configuration screen configure and in drive md motor need to be configured thats all Regards, Ekalavya |
7/7/2011 9:48 AM | |
Posts: 55 Rating: (0) |
thanx to all problem solved and all work fine problem was in cables |
This contribution was helpful to2 thankful Users |
7/7/2011 11:22 AM | |
Joined: 4/23/2010 Last visit: 12/31/2023 Posts: 8092 Rating: (872) |
Power or encoder cable? Open or short? |
7/7/2011 8:35 PM | |
Posts: 2964 Rating: (478)
|
Hello.... Fine problem is solved ...with lots pain.... Looks to be strange.... Regards, Ekalavya |
7/10/2011 1:04 PM | ||||||||
Joined: 4/23/2010 Last visit: 12/31/2023 Posts: 8092 Rating: (872) |
Sorry to interrupt but what was the problem & correct solution? |
|||||||
Follow us on