Skip to Content

support.automation.siemens.com | Technical Forum | Saturday, January 16, 2021 1:00:06 PM

Print

PXC3.E75 in the FAULT state ?

Created by: Vasia Pupkin at: 10/27/2017 2:28 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

10/27/2017 2:28 PM	Rate (0)
Vasia Pupkin Advanced Member Joined: 1/6/2017 Last visit: 12/24/2020 Posts: 55 Rating: (1)	Good time, experts !!! We have a PXC3.E75 with the LED FLT continuously ON ... Is this a hardware error or just something like COMA state and it can be reanimated ? Is it possible to recover the device in some way ?

Suggestion To thank Quote Answer

10/30/2017 2:02 PM	Rate (0)
Albis Silver Expert Joined: 6/4/2010 Last visit: 1/14/2021 Posts: 272 Rating: (65)	Dear Vasia, You have to distinguish between the PXC3.E75 and the PXC3.E75-100A. In case of the PXC3.E75, you can follow the steps below: Interrupt the power supply of the PXC3.E75 controller for 20 seconds Try to connect with the DNT tool If you can reach the controller, please load the firmware again, configure the controller and load the application. You have to replace the controller, in case you cannot reach the controller with the DNT tool anymore Best regards, Albis

Suggestion To thank Quote Answer

10/31/2017 1:34 PM	Rate (0)
Jen_Moderator Moderator Joined: 6/19/2017 Last visit: 1/15/2021 Posts: 4410 Rating: (73)	New question published by Andrey Zozulyak is split to a separate thread with the subject Is there any possible way to download new firmware not using DNT Tool?. Best regards Jen_Moderator

Suggestion To thank Quote Answer