Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

S7-1200 run/stop is stopped

Created by: Superabraziv at: 6/30/2014 8:10 AM (5 Replies)

Rating (0)

Thanks 0

6 Entries

6/30/2014 8:10 AM	Rate (0)
Superabraziv Member Joined: 3/27/2014 Last visit: 10/19/2015 Posts: 5 Rating: (0)	Run the machine when the controller is started in this position When run the machine the controller is started in this position (see the picture) run/stop light is orange. When I start my progect and try to conect to controller -> "Connection to address 192.168.0.1 failed. Connection could not be established. The connection partner is not responding. "What can I do to change to run mode? What happened that starting in this mode? Attachment DSC_1045.JPG (126 Downloads)

Suggestion To thank Quote Answer

6/30/2014 9:08 AM	Rate (0)
Rajesh_s Experienced Member Joined: 10/20/2011 Last visit: 11/27/2019 Posts: 96 Rating: (3)	Dear Superabraziv, Please go to dignostic buffer and found what is the error. Thanks...,,,

Suggestion To thank Quote Answer

6/30/2014 9:16 AM	Rate (0)
Superabraziv Member Joined: 3/27/2014 Last visit: 10/19/2015 Posts: 5 Rating: (0)	dignostic buffer? How to connect with this buffer?

Suggestion To thank Quote Answer

6/30/2014 3:54 PM	Rate (0)
0_Einstein Diamond Expert Joined: 7/7/2010 Last visit: 12/6/2019 Posts: 8266 Rating: (1397)	Superabraziv Run the machine when the controller is started in this position When run the machine the controller is started in this position (see the picture) run/stop light is orange. When I start my progect and try to conect to controller -> "Connection to address 192.168.0.1 failed. Connection could not be established. The connection partner is not responding. "What can I do to change to run mode? What happened that starting in this mode? In your attached image, I do not see the Ethernet/profinet link LEDs lighted. Since you are expected to connect to the s7-1200 using an Ethernet/profinet connection, I would expect those LEDs to be lit. Did you disconnect the network cable before taking the picture?
	science guy
Suggestion To thank Quote Answer

7/3/2014 2:56 PM	Rate (0)
Superabraziv Member Joined: 3/27/2014 Last visit: 10/19/2015 Posts: 5 Rating: (0)	Joining've many times with S7-1200, now just is not working. Network cable is connected when I take pictures. I found the problem, the program was deleted or was stuck after I got a new project then it left. But how is it that the program to wipe out and did not ...

Suggestion To thank Quote Answer

7/4/2014 1:49 PM	Rate (0)
Narrator1 Bronze Member Joined: 3/25/2013 Last visit: 3/21/2019 Posts: 187 Rating: (1)	New question split intostart/stop S7-1200 CPU without using TIA portal. With best regards, Narrator1

Suggestion To thank Quote Answer

| |

Follow us on