Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

S7-1200 (Step7 Basic V10.5) MOVE instruction

Created by: Motion09 at: 2/27/2010 12:58 AM (3 Replies)

Rating (1)

Thanks 0

4 Entries

2/27/2010 12:58 AM	Rate (0)
Motion09 Posts: 3 Rating: (0)	Hi, I am working on a project to convert a PLC program from S7-300 to S7-1200. While using Step 7 basic to create the program for theS7-1200, I am encountering the following problem: When using the MOVE instruction to put an integer number to global DB, I receive the error stating: "The MOVE instruciton only allows data blocks based on SDT/UDT" The same move instruction and definition of the global (shared) data block works fine in Step 7. I have tried a few different things, like creating a different DB that has the "Symbolic Acces Only" option unchecked, but it does not make a difference. Attached is a screen shot of the network described. Any help would be greatly appreciated. Attachment Network.JPG (210 Downloads)
Motion09 Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

2/27/2010 12:35 PM	Rate (1)
Giuliano Advanced Member Joined: 2/29/2008 Last visit: 6/29/2018 Posts: 21 Rating: (14)	Hi, I dont understand 100% your problem... but I'll help you. I think you declared the DB name only and not the variable inside of its DB. Tip: after you choose the DB "DB001_HMI" place in the end of DB name a point e.g "DB001_HMI".xxx, soin this waya variablewill appear automatically. Good luck!
	Last edited by: Giuliano at: 2/28/2010 2:40 PM Last edited by: Giuliano at: 2/27/2010 12:55 PM Giuliano L’Abbate Siemens Ltda Industry Automation Consultor in Micro Automation I IA AS CoC Center of Competence - Micro Automation São Paulo - Brasil
Suggestion To thank Quote Answer

3/1/2010 5:35 PM	Rate (0)
Motion09 Posts: 3 Rating: (0)	Guiliano, Thank you, adding the . (dot) after the DB name was the trick. I guess I was used to typing the DB name and being able to press on the ">>" symbol next to the DB name from the drop down menu to access the data on the DB, but that does not work on the MOVE instruction (it works on other instructions). Thank you for the tip.
Motion09 Posts: 3 Rating: (0)
Suggestion To thank Quote Answer

3/2/2010 2:33 PM	Rate (0)
freefly2009 Member Joined: 11/29/2009 Last visit: 2/19/2013 Posts: 17 Rating: (0)	Sometimes, the prompt didn't appeare after adding a dot. We should input the %DB1.DBW0......

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on