Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

sequence punching machine problems

Created by: AutoGen_567640 at: 1/9/2021 4:38 PM (3 Replies)

Rating (1)

Thanks 2

4 Entries

1/9/2021 4:38 PM	Rate (0)
AutoGen_567640 Member Joined: 4/28/2015 Last visit: 1/14/2021 Posts: 2 Rating: (0)	Hi, would be grateful to get som help with a program with this function: The logical sequence for the execution of the process begins when you press the start button according to how it is established in the space phase diagram The following should be considered The punching cylinder (cylinder B) makes two strokes, the first stroke B of the cylinder is fast and then a second stroke with slow forward, when cylinder B has reached the end of its stroke b1 in its first stroke it must stop for 3 seconds in that position and then return while in your second run you have to stay in that position for 4 seconds and then return. The recoil on cylinder B in its second stroke and cylinder A is at the same time. The process should automatically repeat 6 times and then stop
	Last edited by: AutoGen_567640 at: 01/09/2021 16:39:14 Last edited by: AutoGen_567640 at: 01/09/2021 21:38:30 Last edited by: AutoGen_567640 at: 01/09/2021 21:48:38
Suggestion To thank Quote Answer

1/10/2021 2:57 PM	Rate (0)
dchartier Grandmaster-Expert Joined: 9/27/2006 Last visit: 3/3/2021 Posts: 10454 Rating: (2213)	Hello; Reading the description of the sequence you want to control is a bit confusing. First, what controller/software will you be working with to control this process, what hardware will you be using? You start your description by announcing a space phase diagram, then never show it. Was this provided to you, or do you have to create it? What exactly could you show us? You describe different motions you would like to implement with Cylinder B, and at the end Cylinder A appears, without any introduction... How many cylinders actually intervene in this process? You say you want to control 2 separate motions on Cylinder B, extend/retract a first time, then, expand/retract a second time, with a time gap between the 2 motions. Are these motions both to the end points of the cylinder (complete range), or do you stop somewhere in the middle during the motion? Please clarify better what you want to do, it will be difficult for us to help you more. Hope this helps, Daniel Chartier

Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users mindware

1/11/2021 8:58 AM	Rate (1)
jacek d Platinum Member Joined: 9/23/2005 Last visit: 3/2/2021 Posts: 3193 Rating: (509)	AutoGen_567640 the space phase diagram Maybe you meant a state chart of a finite state machine. Then there.
	Regards, Jacek What is confusing you is the fact that you never see a number but always its digit representation. So you end up thinking that the number is the representation. - Andrej Bauer Any claims against me - based on whatever legal reason - resulting from the use of any code and/or ideas presented on this forum shall be excluded.
Suggestion To thank Quote Answer
This contribution was helpful to 1 thankful Users dchartier

1/11/2021 11:54 AM	Rate (0)
AutoGen_567640 Member Joined: 4/28/2015 Last visit: 1/14/2021 Posts: 2 Rating: (0)	Thank you for your help.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on