Skip to Content
|2/17/2016 11:24 PM|
Last visit: 2/17/2016
When I try to connect it, it immediately damaged, even though the wiring as per the datasheet here https://www.downloads.siemens.com/download-center/Download.aspx?pos=download&fct=getasset&id1=BTLV_43430
The building have L, N ,and Ground , 1 phase 220 V 50Hz
I connect the black wire to the L
The white wire to the N
the green to the ground
device have tape with (120V) even though the device clearly indicate
that the voltage is 240/120V (attached) I doubt it is the problem but I
have to mention it.
I'm going to buy/replace it but I need to know what I did wrong as every thing seems OK until it connected , Any suggestions?
|4/24/2016 9:24 AM|
Last visit: 3/22/2017
In page 2 of the brochure, it is mentioned 120V FS will fail instantaneously (which happened with your site) if you connect to 220V.
Better first you check spare with 120V only. OR write to vendor where from you purchased, to reconfirm the voltage specification
|4/25/2016 1:59 PM|
Last visit: 3/15/2017
|Higher voltage than rated can damage the surge protector completely|
|1/29/2017 8:36 AM|
Last visit: 1/31/2017