Starter Sinamics connection online

Welcome

Im trying connect via STARTER to sinamics drive.

But when im searching for accessible nodes - i have only IP adresses and - no bus information.

Connecting Directly to drive via RJ45 cable..

What i need ? It lacks something ? But what.. Attacching photos..Can some one advise ?

Hello,

possible reasons:

STARTER is to OLD.
Starter SSP for this drive not installed
PC is not in the same subnet like the drives

Which Starter you use and which FW ist used on the drive?

Regards

Christoph

ChristophD

Hello,

possible reasons:

STARTER is to OLD.
Starter SSP for this drive not installed
PC is not in the same subnet like the drives

Which Starter you use and which FW ist used on the drive?

Regards

Christoph

 Hi

Thank you  for interesting

I use STARTER 4.4.1 SP1

Im connecting directly to drive via X129

SSP for that drive, witch is ? I installed some SSP for S120 - but maybe wrong.

Could you help ?

Hi,

which Drive fw is it exactly?

it can be that on the drive a FW is used which is not supported from Starter V4.4!

The FW Version can be read in the file content.txt on the CF Card.

Power OF the CU and remove the Card, insertt the Card in a cardreader on PC and check the content.txt.

Regards

Christoph

ChristophD

Hi,

which Drive fw is it exactly?

it can be that on the drive a FW is used which is not supported from Starter V4.4!

The FW Version can be read in the file content.txt on the CF Card.

Power OF the CU and remove the Card, insertt the Card in a cardreader on PC and check the content.txt.

Regards

Christoph

 OK i will check .. i have to buy CardReader.. On the label of the card someone wrote - 4.5

Whitch SSP should I install ? Maybe i will try it first..

Hello,

SSP_SINAMICS_V4_5 is the one for FW V4.5.

You can look in Starter under help -> installed devices if for CU320-2 is the Version V4.5 installed.

Regards

Christoph