Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

TIA error after CPU change

Created by: Mislec at: 6/5/2011 8:59 PM (2 Replies)

Rating (0)

Thanks 0

3 Entries

6/5/2011 8:59 PM	Rate (0)
Mislec Regular Member Joined: 3/16/2009 Last visit: 1/5/2019 Posts: 9 Rating: (0)	Hi, I'm using a S7 1212C and made a firmware upgrade, because I wan't to use the data loging. The firmware upgrade of the CPU went well, but now i have problems with the change of the CPU in the TIA project. After I made the change of the CPU to the new 2.0 version i'm getting the following error: Home automation,,1,0,8:51:54 PM Hardware configuration,,1,0,8:51:54 PM SIMATIC 1200 station_2, ,1,0,8:51:55 PM S7-1200 rack, ,1,0,8:51:55 PM Home automation, ,1,0,8:51:55 PM PROFINET interface, ,1,0,8:51:55 PM ,PROFINET interface contains too few modules of the type S71200\SUBMODULES\CPU\IE\MDD_Simatic-CPU12xx-Sub-EthernetPort_2.0.,1,0,8:51:55 PM ,Compiling aborted (errors: 1; warnings: 0),1,0,8:51:55 PM Any idea how to solve this error ? Best regards, Kristijan

Suggestion To thank

6/6/2011 2:50 PM	Rate (0)
bakerjw Silver Member Joined: 3/14/2008 Last visit: 5/24/2019 Posts: 126 Rating: (18)	Using the TIA Portal, reset the PLC back to factory defaults, power cycle the PLC and try it again. Sometimes the PLCs need to be cleared after a firmware update.

Suggestion To thank

6/6/2011 3:38 PM	Rate (0)
O_Moderator Diamond Member Joined: 4/24/2009 Last visit: 2/2/2021 Posts: 2694 Rating: (135)	Thread closed, because question is already published in the following thread CPU change error . Best regards O_Moderator
	Tips&Tricks for the forum usage
Suggestion To thank

|

Share this page:

Share this page on...

Follow us on