Transfer error MP277 10" Touch

Hello friends,

I´m trying to transfer a Project.hmi to a operator panel MP277 10" touch, To do that, I configure the transfer option to Ethernet in channel 2. I put the laptop IP into the same range of the panel. (The comm it´s right because I can do ping to the MP277 from my laptop). After open the winCC flexible with the Project execute the following step:

1.- On the MP277 push Transfer

2.- Open winCC flexible with the file .hmi and then Project-Transfer

3.- I Choose Ethernet mode and fill the gap with the IP (MP277 IP of course)

After that, begin to generate, but a message appear:

You cannot transfer. The config you make it´s for a different device than you are connected now.

How can I do? I tried with MPI with the same result

Regards

Hello,

The MLFB it´s

6AV6 643-0CD01-1AX1 and v 1.2

Regards,

Yes, The PG/PC it´s right (broadcom TCP/IP Activ)

Regards,

Diego termosolar

Hello,

The MLFB it´s

6AV6 643-0CD01-1AX1 and v 1.2

Regards,

 from which ist this the data, from the real panel or from the device in the project?

This is from the operator panel

Hello,

Please open your project and go to device settings, then in device type drop down list, tell us what's your selection.

You should go to MultiPanel/ 270/ MP277 10'' Touch

Good morning!

Yes, this is my selection. Could be the versión of the MP?

Regards,