SiePortal

The integrated platform for your product selection, buying and support workflow - bringing together Industry Mall and Online Support.

Products & Services
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Support Support
{{(apiData.Support | filter:{'rank':1}:true)[0].title}} Support
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
MySiePortal MySiePortal
{{(apiData.MySiePortal | filter:{'rank':1}:true)[0].title}} MySiePortal
- Menu temporary not available
- Menue temporary not available
- {{item.title}}
Cart ({{apiData.CartCount}})

Navigation

Fault F117 on simovert vc

9/15/2008 1:37 PM	Rate (0)
tsaros Advanced Member Joined: 6/4/2008 Last visit: 7/25/2024 Posts: 30 Rating: (0)	I had this fault when i changed a cuvc card on a masterdrive.The old cuvc had a problem.On terminal 1 of the X101 control terminal strip i didnt have 24 V,so i changed the card but when i download the parameters to the new card i have F117 fault.The old card was 3.2 version and the new one 3.4 and after the conversion finished and after the dowload finished i had a message 9 parameters were rejected. thank you in advance nikos

Suggestion To thank Quote Answer

9/15/2008 1:52 PM	Rate (0)
Technology Team Platinum Expert Joined: 10/11/2006 Last visit: 11/14/2024 Posts: 5941 Rating: (816)	Hello Tsaros, F117 is a fault message from the technology board (T100, T300 or T400) and I suppose, it is a fault regarding commuication to CU, but the fault number depends on the project in your technology board. For a better diagnosis, you should post the parameters, that were rejected. Did you correct them already to the correct values?
	With best regards, Technology Team Application consulting and pre sales support for SINAMICS, SIMATIC Technology, SIMOTION, SIMOTICS and MOTION CONNECT
Suggestion To thank Quote Answer

9/15/2008 2:09 PM	Rate (0)
legacy support Silver Member Joined: 7/15/2008 Last visit: 10/6/2024 Posts: 382 Rating: (44)	Hello TechTeam Since your new Borad is a newer Firmware Version your download ( .dnl file ) may not wok propperly . Please see this link. http://support.automation.siemens.com/WW/view/en/16626195

Suggestion To thank Quote Answer

9/16/2008 1:51 PM	Rate (0)
tsaros Advanced Member Joined: 6/4/2008 Last visit: 7/25/2024 Posts: 30 Rating: (0)	finally it worked.i used the latest version of drive monitor and the dowload was completed without rejected parameters.the problem with F117 happened again but when i changed the bit 4 on P053 from 0 to 1 the fault was reseted.What i cant understand is that in the back up that i had this bit was 0 and thedrive was working.The tech.board is T300
	Last edited by: tsaros at: 9/16/2008 1:52 PM
Suggestion To thank Quote Answer

Share this page:

Share this page on...