Dear Everybody!

Last month 20 times repeated the F60010 code. Anybody help me.

Tinordi

Tinordi

I attach the parameters. Felcsevelo is the problems drive.

 Hello,

I am not able to open attached file. In which format you have download & save the parameters. 

If possible, can you convert it into pdf  format & attach here?

After unpacking this is the xml format for Internet explorer.

I send it all parameters in pdf file.

Tinordi

Hello,

From the attached data it indicates F60010 is because of average current value through thyristors is excessively low. To find out the exact problem follow below steps.

1. First to find out enable thyristor diagnosis by setting P 50830 = 2, i.e. at each switch ON command thyristors will be checked & then triggered. This will help to find out if the thyristors, impulse trafo, control circuit is healthy or problematic. If this test fails intermittently, then check the connections at thyristors, flat ribbon cables, impulse trafo, power interface board etc. If you have spares try by replacing one by one.

2. If the thyristor diagnosis runs smoothly & even then fault exists, incoming three phase CT connections, CUD1 card & power interface card interconnecting ribbon cables. If everything is OK, try by replacing CUD1 card.

HTH.

Thank You!

I will test it next stop time. It will anytime on next month.

Since you have been struggling with this problem for 6 months, I would strongly suggest that you get in a Siemens Service engineer to help you diagnose your problem.

I could not imagine letting a problem go this long.