Dear Sir,

Provide me a help on how to do reading/writing NC parameters i.e. axis parameter from PLC in 828D V4.7 sp5.

If possible support with an example.

Thanks,

Rohit Jage

Unicorn Controls

Rohit J

Dear Sir,

Provide me a help on how to do reading/writing NC parameters i.e. axis parameter from PLC in 828D V4.7 sp5.

If possible support with an example.

Thanks,

Rohit Jage

Unicorn Controls

Dear Rohit,

PFA, just use this as a reference manual.

its not an official Siemens manual. Its a write up made by Siemens India

Hope this will help you.

Regards/Alfin Paul

Alfin

Dear Rohit,

PFA, just use this as a reference manual.

its not an official Siemens manual. Its a write up made by Siemens India

Hope this will help you.

Regards/Alfin Paul

 Dear Alfin,

thanks for the guidance. this was really helpful to me.