Dear Experts,

I would like to solicit your technical input regarding the Ultramat 23 (SO2 and O2) units we have installed in our SAP Plant stack. We are frequently encountering ******** (fault) reading in SO2 component after autocalibration. We have resetted the unit and after warming-up it proceeded with autocal and everything seems normal and showed the onlineprocess value. But after 23 mins it again performed the second calibration(which as per manual is part of the warm-up procedure) then the reading for SO2 went ******. The oxygen reading remains ok.

We have checked the integrity of our sample handling systems and evrything seems ok.
What actions should we take to solve this problem?
If were going to proceed with cleaning the sample chamber, what are the procedures that we should follow? Can we use isopropyl alcohol to purge the sample cell?

Thank you very much sir. And your inputs will be highly valued.

Best Regards,

EDWIN, KSA

New question published by ChristPegop is split to a separate thread with the subject ULTRAMAT 23, autocal drift beyond tolerance.

Best regards
Min_Moderator