Hello expert.

I am using SIMOTION rotary knife V3.1 with scout tia.

so, When i operating to manual mode in the HMI, simotion is going to stop mode.

My system configuration is one ALM(380kw), three SMM(315kW, 32kW, 0.75kW), D445-2

ALM sampling time is 375, other SMM is 125.

when i am order to RUN mode in online, occur fault of alm, number is 1910.

so, I accept to reset and operate to again on the HMI .

SIMOTION is go to stop mode.

what can i do for solve this problems?

if i doing programming in the TechnoloicalFaultTask or ShutdownTask, how to do programming?

please give to me help.

Thanks.

Make sure all required taks are loaded, even if empty. Use some template program, I forgot which task exactlly must be present.

This question was posted twice. Please continue here:

https://support.industry.siemens.com/tf/de/en/posts/150718/

Best regards

The Helping Hand