Dear all experts

i will online hardware configuration of CPU in TIA portal and it give module wise diagnose buffer and also shows the which module is faulty and which is not reachable it is to good.

But if i will change in hardware property on offline mode and then goes to online  without downloading a hardware it shows online mode but it does not give the mismatch popup as shows in SIMATIC manager.

is there any solution of it? because some time it make serious problem on logical site.

please give update on it..

Give best idea of it.

SANDY GORASIYA

Dear all experts

i will online hardware configuration of CPU in TIA portal and it give module wise diagnose buffer and also shows the which module is faulty and which is not reachable it is to good.

But if i will change in hardware property on offline mode and then goes to online  without downloading a hardware it shows online mode but it does not give the mismatch popup as shows in SIMATIC manager.

is there any solution of it? because some time it make serious problem on logical site.

please give update on it..

Give best idea of it.

 Please explain your installed version of Tia

If it's older please update, 

If possible please upload photos of your faced problem.

Hello,

try for first re-compile HW, then try go ONLINE what TIA shows.

Hello SANDY GORASIYA,

                                  In TIA Directly Going to Offline And Make Changed In configuration And Came to Program After That Ur Directly Going (Project Not Saved), To Online Monitor Means There Is No means Of changed ur Hardware . So please Save and Compile The project And Check It .

If I could help you, You can always use Thank and Rate buttons :)

Suggestion was helpful? Thanks to rate it

 Regards,

Thanks to all expert,

I will check it on hardware,

Then give you answer it. What happening after a compilied and saved.

Thanks again.