Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Transfering PAC3200 settings

Created by: Abyrne at: 9/21/2009 10:50 AM (6 Replies)

Rating (0)

Thanks 0

7 Entries

9/21/2009 10:50 AM	Rate (0)
Abyrne Bronze Member Joined: 11/26/2008 Last visit: 12/8/2023 Posts: 101 Rating: (4)	Hello, I am wondering can the settings and values of one PAC3200 be transfered to another one? If so how is this done? Thanks for your help

Suggestion To thank Quote Answer

9/22/2009 12:38 PM	Rate (0)
LesPaul Posts: 467 Rating: (59)	hello Abyrne, The attitudes can be copied by a PAC3200 on another one. This can be made about the enclosed configuration software Sentron powerconfig. kind regards
LesPaul Posts: 467 Rating: (59)
Suggestion To thank Quote Answer

9/22/2009 1:39 PM	Rate (0)
Abyrne Bronze Member Joined: 11/26/2008 Last visit: 12/8/2023 Posts: 101 Rating: (4)	Thanks for the reply LesPaul, The atributes i need to transfer relate to measured values and active hours etc. not TCP/IP address, masks or firmware versions. I think the Sentron software can only transfer these settings. I am looking to replace a damaged meter with a new one, but transfer the logged data from the old meter to the new one. Can a memory card be used for this? I see there is a slot for a memory card in the back of the meter.

Suggestion To thank Quote Answer

9/25/2009 11:59 AM	Rate (0)
woko Posts: 1 Rating: (0)	I guess that you try to transfer the values of an energie counter to an other PAC3200. I think that this is not possible. The software powerconfig can be used for configuration. A memorycard can't be fitted to PAC3200.
woko Posts: 1 Rating: (0)
Suggestion To thank Quote Answer

5/20/2014 6:14 PM
@nkur Posts: 202 Rating: (16)	Abyrne Hello, I am wondering can the settings and values of one PAC3200 be transfered to another one? If so how is this done? Thanks for your help Hi There You cannot transfer the settings & values of PAC3200 to other
@nkur Posts: 202 Rating: (16)
Suggestion Quote Answer

5/21/2014 7:19 AM
ashishmistry390 Posts: 21 Rating: (0)	Abyrne Hello, I am wondering can the settings and values of one PAC3200 be transfered to another one? If so how is this done? Thanks for your help A SENTRON PAC3200 Powermonitoring Device is used for measuring of voltage and current. In countries where UL standards are applied, a SENTRON PAC3200 can measure voltages up to 600V phase-to-phase directly without a voltage transformer. For countries with IEC standards up to 690V phase-to-phase may be measured directly without a voltage transformer. Current measurements are done with a current transformer per phase.
ashishmistry390 Posts: 21 Rating: (0)
Suggestion Quote Answer

5/21/2014 9:11 AM	Rate (0)
Madhava Silver Member Joined: 11/26/2011 Last visit: 6/29/2023 Posts: 508 Rating: (23)	Transferring the data Energy Consupmtion etc to another device is not possible.

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on