12/22/2023 9:20 AM | |
Joined: 11/4/2011 Last visit: 7/12/2024 Posts: 228 Rating:
|
Hi there, to put it short: You're right about the interference suppression frequency causing the cycle time of the module (at least the largest part of it). In detail: Unfortunately I could not find a statement about the sequential working in the technical data (https://support.industry.siemens.com/cs/de/en/view/109475183/76346357899), but perhaps I just missed it. Information about the interference suppression frequency and how it should be set can be found here: https://support.industry.siemens.com/cs/de/en/view/67989094/61580316171 I'm a little lazy right now ( Regards, |
Last edited by: daviso at: 12/22/2023 09:22:49fixed typo |
|
This contribution was helpful to
2 thankful Users |
Follow us on