Skip to Content

Register Login

Industry Online Support

Technical Forum

Navigation

Power supply not showing in online

Created by: Sankar at: 2/14/2013 7:54 PM (5 Replies)

Rating (0)

Thanks 0

6 Entries

2/14/2013 7:54 PM	Rate (0)
Sankar Experienced Member Joined: 12/2/2010 Last visit: 4/2/2024 Posts: 61 Rating: (0)	Hi, am using PS 407 10A(407-0KA02-0AA0) Hardware in my project and the same configured in Siemens hardware configuration. When I was checked the power supply in online it showing Actual/Present mismatch. Afterthat once again I checked the hardware prat no. and software pare no. is of the power supply both are same. What is the problem. Software: Siemens Step 7 V5.4 SP4 CPU : 416-3 DP( 416-3XR05-0AB0) V5.3.1 Regards\Sankar Attachment POWER SUPPLY MODULE.jpg (194 Downloads)
	Regards \ Sankar
Suggestion To thank Quote Answer

2/14/2013 8:02 PM	Rate (0)
UMENCHO Diamond Member Joined: 3/21/2006 Last visit: 11/1/2024 Posts: 10229 Rating: (1181)	Are you sure physical hardware is the same as in hardware configuration? Best regards, Hristo Mihalev

Suggestion To thank Quote Answer

2/14/2013 8:34 PM	Rate (0)
Sankar Experienced Member Joined: 12/2/2010 Last visit: 4/2/2024 Posts: 61 Rating: (0)	Hi, Hardware Photo for your reference Attachment DSC04558.JPG (183 Downloads)
	Regards \ Sankar
Suggestion To thank Quote Answer

2/15/2013 9:42 AM	Rate (0)
Jazz_M Gold Member Joined: 9/6/2008 Last visit: 5/7/2022 Posts: 1121 Rating: (86)	Hi Try Uploading your project from the controller, It will assign all the MLFB no from the Connected system. Check that out.
	Jazz
Suggestion To thank Quote Answer

2/17/2013 5:54 PM	Rate (0)
Sankar Experienced Member Joined: 12/2/2010 Last visit: 4/2/2024 Posts: 61 Rating: (0)	Hi, I uploaded the hardware configuration from the cpu but still power supply showing Preset/Actual is mismatch.
	Regards \ Sankar
Suggestion To thank Quote Answer

2/27/2013 9:00 AM	Rate (0)
Cicero Gold Member Joined: 10/10/2005 Last visit: 10/18/2024 Posts: 1921 Rating: (136)	Hello, delete the SDBs (system data blocks) in the SIMATIC Manager and save and compile the HWconfig again. Load the HWkonfig in the CPU. The reason could be a version conflict between two PC and/or STEP 7 versions if you change the work stations. With best regards Cicero

Suggestion To thank Quote Answer

|

Share this page:

Share this page on...

Follow us on