Problem installing ProTool ver 6.0 SP3 Hotfix 3

Try thid way - Use Disk Cleanup to Remove Files You Do Not Need

1. Open My Computer.
2. Right-click the disk you want to free space on, and then click Properties.
3. On the General tab, click Disk Cleanup.
4. Click the files you want to remove, and then click OK.

It seems Windows needs a certain amount of hard drive space available to operate efficiency, and from my experience, when I have this issue, Windows doesn’t give you an accurate reading of how much space is actually on the hard drive (for some reason -- I could speculate as to why this is,.

Right click on ‘My Computer’.

1. In the ‘System Properties’ window that comes up, left click on the ‘Advanced’ tab
   
   .
2. Left click on ‘Settings’ under the ‘Performance’ heading
   
   .
3. In the ‘Performance Options’ window that comes up, left click on the advanced tab
   
   .
4. Left click on ‘Change’ under the ‘Virtual Memory’ heading
   
   .
5. Find the drive that you are having the space issues with, left click on it (it should be under the ‘Drive [Volume label]’ heading), and look how much space you have available under the ‘Paging file size for selected drive’ heading
   
   .
6. Now look at how much space you have allocated as virtual memory in both ‘Initial size (MB)’ and ‘Maximum size (MB)’ under the ‘Paging file size for selected drive’ heading
   
   .
7. If you find the amount of hard drive space allocated to virtual memory is disproportionate to the amount of hard drive space you have available, or if you simply would like to reduce the amount of memory you have available to see if it can resolve the issue you’re having, you may want to consider reducing the amount of virtual memory (note: if you reduce the amount of virtual memory you have allocated to your drive it is likely to impact your system performance, depending on how much virtual memory you have allocated. Keep this in mind should you decide to make some changes)
   
   .
8. To reduce the allocated amount of virtual memory simply reduce the values in both ‘Initial size (MB)’ and ‘Maximum size (MB)’ under the ‘Paging file size for selected drive’ heading by however much you want by typing in new, lower values (I’d probably get rid of about 500mb + however much space Msn Messenger takes up, but it’s up to you), then left click on ‘Set’ and then on ‘Ok’. Bare in mind that you need to get rid of enough virtual memory if you actually want to make a difference (again, I’d probably get rid of about 500mb + however much space Msn Messenger takes up, but it’s up to you)

A case is already activated at the Siemens support!
So I just waiting fora solution of my problem.


Thanks anyway!
//Apollo11

Did you get any solution?

I have to program an OLD HMI and I have the same problem

Regards, Luis