about SM321 module

RetroK

Can you tell me where is the No1, and 10,11,21,30,31 in SM321 module that I attatched.

Hello RetroK,

The position that you have circled is correct, 

you can also look oh the front connector e.g. 6ES7 392-1AM00-0AA0 and you will find the number:

6ES7392-1AM00-0AA0 - Product Details - Industry Mall - Siemens WW

Hi

The circled terminals are not used in the module in question.

In OUTPUT modules these are used for +24V supply which supplies each group of outputs.

This way some outputs can be supplied at all times (for example these driving indication lamps)

and others are supplied when E-Stop is not operated ONLY (for example these driving actuators,

solenoids, etc.)

in this case You should leave these terminals not connected.

Hope this helps

Piotr

RetroK

Thank you very much, but it's not what I want to know.
  I would like to know why there are no numbers in the red circled area.
Is the missing numbers are useless parts?

Hello RetroK,

In the INPUT module (SM321) it is not necessary to power with +24 Vdc, where you've marked the red circles (1,11,21,31) usually this terminal is for + 24Vdc. Almost all DI modules except the 6ES7 321-7BH01-0AB0 that have Hardware and Diagnostic Interrupt this must be powered to terminal 1 and if I remember correctly even someone else

Hello,

for the DI32 yes is useless.

Show on tme SM322 32 DO then this connectors not useless

for both Signalmodules you use the same front connector.

Regards
Christoph